help

[chris-n/jUll39koHNgV/OU4+dkA at public.gmane.org]

Lennart Sorensen writes: 

> On Wed, Jan 30, 2008 at 11:51:23AM -0500, Dave Germiquet wrote:
>> I'm not sure if I'm out on a whim here, maybe someone else could say
>> if im right or wrong but is it possible the irq's are conflicting?
> 
> Seems unlikely given it is a PCI card. 
> 
> The message from the driver saying "can't load firmware file" seems more
> likely to be a problem.

I don't think this is the problem any more. I think this dmesg output all 
looks good: 

[   47.313984] emu1010: Special config.
[   47.314103] emu1010: EMU_HANA_ID=0x7f
[   47.486647] 
/build/buildd/linux-source-2.6.22-2.6.22/drivers/usb/class/usblp.c: usblp0: 
USB Bidirectional printer dev 2 if 1 alt 0 proto 2 vid 0x03F0 pid 0x4811
[   47.486709] usbcore: registered new interface driver usblp
[   47.486720] 
/build/buildd/linux-source-2.6.22-2.6.22/drivers/usb/class/usblp.c: v0.13: 
USB Printer Device Class driver
[   48.106570] firmware size=0x133a4
[   50.500129] eth0: no IPv6 routers present
[   51.196134] emu1010: Hana Firmware loaded
[   51.196185] Hana ver:3.4
[   51.196245] emu1010: Card options=0x1
[   51.196272] emu1010: Card options=0x1
[   51.196758] emu1010: Card options3=0x1
[   51.314247] EMU outputs on
[   51.314263] EMU inputs on 


> May even be going to alsa 1.0.15 rather than 1.0.14rc would solve the
> problem too.

I guess I can't install that with apt-get... 

Chris 

> --
> Len Sorensen
> --
--
The Toronto Linux Users Group.      Meetings: http://gtalug.org/
TLUG requests: Linux topics, No HTML, wrap text below 80 columns
How to UNSUBSCRIBE: http://gtalug.org/wiki/Mailing_lists