semi-pro PCI snd crd for linux

Chris Aitken chris-n/jUll39koHNgV/OU4+dkA at public.gmane.org
Mon Sep 3 00:42:08 UTC 2007


Tyler Aviss wrote:
> Are there ISA devices in this system? 
No - only PCI slots. In fact, the EMU 1212 M is the only installed card 
- everything else is onboard.
> Shouldn't run into IRQ issues
> when you're with just PCI, but sometimes if you have an older board
> with - say - an ISA modem or whatnot it may conflict
>
> To get detailed info on your PCI devices (including IRQ's):
> lspci -vv
>   

[chris at p733 ~]$ /sbin/lspci -vv
00:00.0 Host bridge: Intel Corporation 82815 815 Chipset Host Bridge and 
Memory Controller Hub (rev 02)
        Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- 
ParErr- Stepping- SERR+ FastB2B-
        Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=fast >TAbort- 
<TAbort- <MAbort+ >SERR- <PERR-
        Latency: 0
        Capabilities: <access denied>

00:02.0 VGA compatible controller: Intel Corporation 82815 CGC [Chipset 
Graphics Controller] (rev 02) (prog-if 00 [VGA])
        Subsystem: Compaq Computer Corporation Unknown device 0019
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- 
ParErr- Stepping- SERR- FastB2B-
        Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- 
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 0
        Interrupt: pin A routed to IRQ 21
        Region 0: Memory at 44000000 (32-bit, prefetchable) [size=64M]
        Region 1: Memory at 40500000 (32-bit, non-prefetchable) [size=512K]
        Capabilities: <access denied>

00:1e.0 PCI bridge: Intel Corporation 82801 PCI Bridge (rev 01) (prog-if 
00 [Normal decode])
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- 
ParErr- Stepping- SERR+ FastB2B-
        Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=fast >TAbort- 
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 0
        Bus: primary=00, secondary=02, subordinate=02, sec-latency=64
        I/O behind bridge: 00001000-00001fff
        Memory behind bridge: 40000000-404fffff
        Secondary status: 66MHz- FastB2B+ ParErr- DEVSEL=medium >TAbort- 
<TAbort- <MAbort- <SERR- <PERR-
        BridgeCtl: Parity- SERR+ NoISA+ VGA- MAbort- >Reset- FastB2B-

00:1f.0 ISA bridge: Intel Corporation 82801BA ISA Bridge (LPC) (rev 01)
        Control: I/O+ Mem+ BusMaster+ SpecCycle+ MemWINV- VGASnoop- 
ParErr- Stepping- SERR+ FastB2B-
        Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- 
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 0

00:1f.1 IDE interface: Intel Corporation 82801BA IDE U100 Controller 
(rev 01) (prog-if 80 [Master])
        Subsystem: Intel Corporation Unknown device 2411
        Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- 
ParErr- Stepping- SERR- FastB2B-
        Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- 
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 0
        Region 0: [virtual] Memory at 000001f0 (32-bit, 
non-prefetchable) [disabled] [size=8]
        Region 1: [virtual] Memory at 000003f0 (type 3, 
non-prefetchable) [disabled] [size=1]
        Region 2: [virtual] Memory at 00000170 (32-bit, 
non-prefetchable) [disabled] [size=8]
        Region 3: [virtual] Memory at 00000370 (type 3, 
non-prefetchable) [disabled] [size=1]
        Region 4: I/O ports at 2460 [size=16]

00:1f.4 USB Controller: Intel Corporation 82801BA/BAM USB Controller #1 
(rev 01) (prog-if 00 [UHCI])
        Subsystem: Intel Corporation Unknown device 2411
        Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- 
ParErr- Stepping- SERR- FastB2B-
        Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- 
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 0
        Interrupt: pin C routed to IRQ 16
        Region 4: I/O ports at 2440 [size=32]

00:1f.5 Multimedia audio controller: Intel Corporation 82801BA/BAM AC'97 
Audio Controller (rev 01)
        Subsystem: Compaq Computer Corporation Compaq Deskpro EN Audio
        Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- 
ParErr- Stepping- SERR- FastB2B-
        Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- 
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 0
        Interrupt: pin B routed to IRQ 20
        Region 0: I/O ports at 2000 [size=256]
        Region 1: I/O ports at 2400 [size=64]

02:08.0 Ethernet controller: Intel Corporation 82801BA/BAM/CA/CAM 
Ethernet Controller (rev 01)
        Subsystem: Compaq Computer Corporation EtherExpress PRO/100 VM
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- 
ParErr- Stepping- SERR+ FastB2B-
        Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- 
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 66 (2000ns min, 14000ns max), Cache Line Size: 32 bytes
        Interrupt: pin A routed to IRQ 17
        Region 0: Memory at 40100000 (32-bit, non-prefetchable) [size=4K]
        Region 1: I/O ports at 1000 [size=64]
        Capabilities: <access denied>

02:0a.0 Multimedia audio controller: Creative Labs SB Audigy (rev 03)
        Subsystem: Creative Labs E-MU 1010
        Control: I/O+ Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- 
ParErr- Stepping- SERR+ FastB2B-
        Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- 
<TAbort- <MAbort- >SERR- <PERR-
        Interrupt: pin A routed to IRQ 19
        Region 0: I/O ports at 1040 [size=32]
        Capabilities: <access denied>

02:0a.2 FireWire (IEEE 1394): Creative Labs SB Audigy FireWire Port (rev 
01) (prog-if 10 [OHCI])
        Subsystem: Creative Labs SB Audigy FireWire Port
        Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- 
ParErr- Stepping- SERR+ FastB2B-
        Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- 
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 66 (500ns min, 1000ns max), Cache Line Size: 32 bytes
        Interrupt: pin B routed to IRQ 18
        Region 0: Memory at 40200000 (32-bit, non-prefetchable) [size=2K]
        Region 1: Memory at 40000000 (32-bit, non-prefetchable) [size=16K]
        Capabilities: <access denied>

[chris at p733 ~]$

<snip>
--
The Toronto Linux Users Group.      Meetings: http://gtalug.org/
TLUG requests: Linux topics, No HTML, wrap text below 80 columns
How to UNSUBSCRIBE: http://gtalug.org/wiki/Mailing_lists





More information about the Legacy mailing list