<div dir="ltr"><div><snip><br></div><div class="gmail_quote"><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">
> So it has USB boot with the Pi 4 I just have to change the <br>
> FIRMWARE_RELEASE_STATUS value from "critical" to "stable."<br>
<br>
I would err on the side of sticking with just a high quality SD card. <br>
There far less chance of the accidental removal while the machine is in <br>
operation.<br></blockquote><div><br></div><div>Very true :-) <br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">
<br>
When you also factor in Keyboard, Mouse, and USB boot drive, your left <br>
with only one spare USB port, which could likely be taken up by a <br>
webcam. Sticking to the SD keeps one more port free for incidental use.<br>
<br></blockquote><div>What if I plug in a USB extender say with 4 ports ? Will that work or use</div><div>too much power  ?</div><div> </div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">
> Alright I will shop around for a fan and aluminium case.<br>
<br>
<br>
It's a bit on the pricey side, but this Argon ONE is nice desktop style <br>
case. The power button also helps to make sure it's not being hard <br>
powered off, possible leading to corruption of the boot filesystems.<br>
<br>
<a href="https://www.youtube.com/watch?v=8VlE654abDo" rel="noreferrer" target="_blank">https://www.youtube.com/watch?v=8VlE654abDo</a><br>
<a href="https://www.buyapi.ca/product/argon-one-pi-4-raspberry-pi-case/" rel="noreferrer" target="_blank">https://www.buyapi.ca/product/argon-one-pi-4-raspberry-pi-case/</a></blockquote><div><br></div><div>That is a nice case. They have so many I have to see what else is</div><div>available then decide. But that is a neat case.<br></div><div> </div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">
<br>
>     That being said, I will give one further thing to consider.<br>
> <br>
>     A Raspberry Pi 4 - 8GB is going to run you around $100 Canadian, +<br>
>     $30-50 for a good case, $15 for PSU, $30-80 for SD card or other<br>
>     storage. That's $200 or more. Well with in the lower ends of the<br>
>     used or<br>
>     refurbished desktop and laptops.<br></blockquote><div><br></div><div>Cost is always a concern.</div><div> <br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">
> <br>
>     - <a href="https://www.freegeektoronto.org/shop/" rel="noreferrer" target="_blank">https://www.freegeektoronto.org/shop/</a><br>
>     - <a href="https://www.canadacomputers.com/index.php?cPath=7_158_1934&sort=3a" rel="noreferrer" target="_blank">https://www.canadacomputers.com/index.php?cPath=7_158_1934&sort=3a</a><br>
>     - <a href="https://www.canadacomputers.com/index.php?cPath=710_374&sort=3a" rel="noreferrer" target="_blank">https://www.canadacomputers.com/index.php?cPath=710_374&sort=3a</a><br>
> <br>
>     Can you tell us more about how you expect to use the computer?<br>
>     That would let us help narrow down your options more.<br>
> <br>
> <br>
> This is not for me. My uncle lives in Edmonton. He is in his late 70's <br>
> and getting on.<br>
> I visited him recently and he has an ancient desktop and my aunty has a <br>
> laptop. Both<br>
> run Windows 10. The modem+router is in their basement. The house has 3 <br>
> levels. So<br>
> the wifi signal has to get through two floors for my uncle and one floor <br>
> for my aunty. Most<br>
> times things are extremely slow. I could run an ethernet cable from the <br>
> basement and wire<br>
> a direct connection but did not have the time to do that this time.<br>
> <br>
> I have a couple of desktops lying around but Canada Post or Fedex or UPS <br>
> will be<br>
> very expensive if I was to ship them to Edmonton from Toronto and both <br>
> my uncle and aunt<br>
> are not technically savvy or inclined so even if I get it across someone <br>
> has to hook up and test<br>
> things before handing over to them.<br>
> <br>
> This is when I started exploring possible alternatives. A Pi has a very <br>
> small form factor. Easily<br>
> packaged and can be sent through Canada Post. Or if I manage to save <br>
> enough to fly to Edmonton<br>
> carrying a Pi or two will not be a issue as compared to checking in two <br>
> desktops :-)<br>
<br>
<br>
Yup, remote support and shipping requirements really do lean into the <br>
Raspberry Pi's favor here.<br></blockquote><div><br></div><div>Yes that is the prime reason I started investigating the Pi :-) <br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">
<br>
<br>
> And since everything will be set to go all they have to do is plug in <br>
> the keyboard+mouse+monitor<br>
> or TV and things should just work ? I still have to run a ethernet cable <br>
> from the basement up<br>
> to his room and my aunt's laptop which has no fixed location. Most times <br>
> she uses it in the<br>
> kitchen or dining table.<br>
> <br>
> Oh one more question, what can I do to increase the wifi signal from the <br>
> basement up 3 floors ?<br>
> I have very limited experience with modems and routers.<br>
<br>
There are wifi repeaters, but I've not had much experience with them to <br>
make a recommendation.<br>
<br>
A more practical approach is to move the ISP modem/router onto the <br>
middle floor so that it's coverage is more consistent across the property.<br></blockquote><div><br></div><div>The entry point for the ISP is in the basement and moving things up to the</div><div>main floor is going to get messy. I have to find a way to get a stronger signal</div><div>without messing with the modem/router where it currently is in the basement.</div><div>Running an ethernet cable is a option but I have to get to Edmonton to do this.<br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">
<br>
If it's not practical to do so, because of where their internet service <br>
enters the property, consider getting a second dedicate WIFI router. <br>
Turn off the WIFI on the ISP modem/router. Setup WIFI on the new router, <br>
disable it's DHCP services, and connect one of its LAN side ports back <br>
to one of the LAN side ports of the ISP modem/router.<br></blockquote><div><br></div><div>This will definitely work. I have to first learn and familiarize myself with setting</div><div>up a modem/router. Thank you Scott.<br></div><div> </div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">
<br>
-- <br>
Scott Sullivan<br>
---<br>
Post to this mailing list <a href="mailto:talk@gtalug.org" target="_blank">talk@gtalug.org</a><br>
Unsubscribe from this mailing list <a href="https://gtalug.org/mailman/listinfo/talk" rel="noreferrer" target="_blank">https://gtalug.org/mailman/listinfo/talk</a><br>
</blockquote></div></div>