[GTALUG] micro controllers

[Jim Ruxton]

You could also take a look at Microchip Curiosity boards; 
https://www.microchip.com/promo/curiosity-development-boards

On 2021-02-16 3:05 p.m., D. Hugh Redelmeier via talk wrote:
> | From: o1bigtenor via talk <talk at gtalug.org>
>
> | I'm wanting to use micro controllers in more of an industrial setting.
> | Don't want to spend the $$$$$$$$$$$ to get the officially hardened etc
> | etc etc models.
>
> If you value your time, unless you are replicating a lot of systems,
> paying for more hardware to save grief is probably worthwhile.
>
> Me?  Too often I value my time too little and end up with more work
> than I have time.
>
> That's purely generic advice.  I cannot give better because
>
> 1) I'm no expert.
>
> 2) you failed to disclose anything about your requirements.
>
>
> If you want to see SBC porn for amateurs, I recommend
> <https://www.cnx-software.com/>
> ---
> Post to this mailing list talk at gtalug.org
> Unsubscribe from this mailing list https://gtalug.org/mailman/listinfo/talk